Recently Updated Pages
How to Enable/Disable the Terminating Resistor on Elseta ConMod P1
This procedure involves opening the device casing. Handle the PCB with care and ensure you are ...
Documentation
General IOMOD modules Step file -> Download IOMOD 8DI4RO FIRMWARE VERSION 1 ...
Firmware and tools
IOMOD Firmware version 2 Downloads Only the Modbus RTU protocol is fully tested for this firmwar...
Firmware update
To upgrade the firmware (FW) of the WCC Lite, open the web interface and navigate to System → Bac...
Single point to double point and double point to single point information
Single point to double point information This example shows how to convert single point informat...
Connecting IOMod 16DI to the WCC Lite
Description This article describes connecting and configuring IOMOD 16DI to the WCC Lite using I...
IOMOD 8DI8DO User Manual
1. Introduction The IOMod 8DI8DO is a compact, standalone digital input and output co...
IOMOD 8DI4RO User Manual
1. Introduction IOMod 8DI4RO is a stand-alone digital input and relay output controller. This de...
Modbus RTU to DNP3 protocol conversion
Setup The article describes WCC Lite configuration steps to enable Modbus RTU protoco...
IOMod 4RTD User Manual
1. Introduction IOMod 4RTD is a standalone temperature sensor device. Designed to measure temper...
IOMOD FPI User Manual
1. Introduction IOMod FPI stands for Fault Passage Indicator. It is an intelligent electronic de...
IOMOD 8AI User Manual
1. Introduction IOMOD 8AI is a compact analog input module, designed for industrial applications...
IOMOD 4Cs4Vs User Manual
1. Introduction IOMod 4Cs4Vs is a compact-sized stand-alone power meter for measuring analog AC ...
IOMod 16DI user manual
1. Introduction The IOMod 16DI is a compact, standalone digital input controller compatible with...
Firmware and tools
WCCLite firmware version 1.11.0 (released 21/03/2025) To upgrade WCC Lite from older versions (u...
IOMod Meter User Manual
1. Introduction IOMod Meter is a compact-sized, stand-alone power meter for measuring analog AC ...
DLMS Serial to IEC104 protocol conversion
Description The article describes WCC Lite configuration steps to enable DLMS Serial ...
Modbus RTU to IEC104 protocol conversion
Setup This article describes WCC Lite configuration steps to enable Modbus TCP protocol conversi...
DLMS TCP to DNP3 protocol conversion
Setup The article describes WCC Lite configuration steps to enable DLMS tcp protocol ...
8.3 Protocol Hub
The Protocol HUB section stores the configuration for every connected device. You can configure i...