Recently Updated Pages

Overview Windlog protocol is used for communications with the Windlog data logger. Configuratio...

Overview M-Bus or Meter-Bus is a protocol for the remote reading of water, gas, or electricity m...

Overview Kostal protocol is used to communicate with Kostal devices over serial communication. ...

Overview System The system section in the status tab shows basic information about the system...

SMS receiver is a service responsible for command execution that was received via text message. T...

This document is intended to act as a user manual and explain WCC Lite usage in detail. It is exp...

It provides the main navigation through the website. Contains the following sections: PROTOC...

IEC 61499-1 defines the architecture for distributed systems. In IEC 61499 the cyclic execution m...

The PLC functionality in the WCC Lite is implemented using the Eclipse 4diac framework, consist...

After a project has been built and bound to an existing Excel configuration, a user would normall...

After the PLC design is finished and debugged, such a design can be compiled into an FBOOT file a...

WCC Lite integrates 1 signal relay (3-way RO connector) with COM (common), NC (normally closed), ...

With WCC Lite hardware version 1.4, a digital input functionality has been introduced. Software c...

For hardware versions older than version 1.4, in case a Wi-Fi connection is needed, connect a Wi-...

WCC Lite comes with a static network configuration with its IP set to 192.168.1.1. For initial se...

The Protocol HUB section stores the configuration for every connected device. You can configure i...

Single point Commonly used in storing digital states single point values have only one bit of in...

WCC Lite comes with an optional GSM module.There are a few hardware configurations available:  ...

WCC Lite can be used as a master station to collect data from IEC 61850 compatible server devices...

WCC Lite can act as an IEC 61850 server to serve data to remote SCADA systems. For example, WCC L...