Recently Updated Pages
26.1 Introduction
SMS receiver is a service responsible for command execution that was received via text message. T...
1 Overview
This document is intended to act as a user manual and explain WCC Lite usage in detail. It is exp...
8.2 Site layout
It provides the main navigation through the website. Contains the following sections: PROTOC...
20.1 IEC 61499
IEC 61499-1 defines the architecture for distributed systems. In IEC 61499 the cyclic execution m...
20.2 4Diac framework
The PLC functionality in the WCC Lite is implemented using the Eclipse 4diac framework, consist...
20.5 Debugging an IEC 61499 application
After a project has been built and bound to an existing Excel configuration, a user would normall...
20.6 Generating and uploading FORTE logic file
After the PLC design is finished and debugged, such a design can be compiled into an FBOOT file a...
6.2 Relay output
WCC Lite integrates 1 signal relay (3-way RO connector) with COM (common), NC (normally closed), ...
6.3 Digital Input
With WCC Lite hardware version 1.4, a digital input functionality has been introduced. Software c...
6.5 Wi-Fi
For hardware versions older than version 1.4, in case a Wi-Fi connection is needed, connect a Wi-...
8.1 Initial Setup
WCC Lite comes with a static network configuration with its IP set to 192.168.1.1. For initial se...
7 Tags
Single point Commonly used in storing digital states single point values have only one bit of in...
6.4 GSM
WCC Lite comes with an optional GSM module.There are a few hardware configurations available: ...
15.3 IEC 61850 Client
WCC Lite can be used as a master station to collect data from IEC 61850 compatible server devices...
15.2 IEC 61850 Server
WCC Lite can act as an IEC 61850 server to serve data to remote SCADA systems. For example, WCC L...
15.1 Introduction
IEC 61850 is an international standard defining communication protocols for intelligent electroni...
8.7 Network
The page shows information about the current interface status, and its configurations, provides...
17.1 DLMS/COSEM
Introduction IEC 62056 is a set of standards for electricity metering data exchange by the Inter...
16.1 At command
Overview At command protocol is used for communications with AT Commands. Configuration At com...
16.3 COMLYNX
Overview Comlynx protocol is used to communicate with Comlynx inverters over serial communicatio...