Recently Updated Pages

Introduction IEC 61107, currently IEC 62056-21, was an international standard for a computer pro...

Overview Elgama protocol is used for communications with Elgama elektronika electricity meters. ...

Overview Ginlong protocol is used to communicate with Ginlong inverters over serial communicatio...

Overview SMA Net can transfer SMA Data, TCP/IP and many more telegrams due to its multi­protocol...

Overview Solplus protocol is used to download inverter data from Solplus inverters using an HTTP...

Overview Vbus is a protocol used for communication with solar station automation via serial link...

Overview Vestas is a protocol used for communication with solar station automation via serial li...

Overview System The system section in the status tab shows basic information about the system...

SMS receiver is a service responsible for command execution that was received via text message. T...

This document is intended to act as a user manual and explain WCC Lite usage in detail. It is exp...

It provides the main navigation through the website. Contains the following sections: PROTOC...

IEC 61499-1 defines the architecture for distributed systems. In IEC 61499 the cyclic execution m...

The PLC functionality in the WCC Lite is implemented using the Eclipse 4diac framework, consist...

After the PLC design is finished and debugged, such a design can be compiled into an FBOOT file a...

WCC Lite integrates 1 signal relay (3-way RO connector) with COM (common), NC (normally closed), ...

With WCC Lite hardware version 1.4, a digital input functionality has been introduced. Software c...

For hardware versions older than version 1.4, in case a Wi-Fi connection is needed, connect a Wi-...

WCC Lite comes with a static network configuration with its IP set to 192.168.1.1. For initial se...

Single point Commonly used in storing digital states single point values have only one bit of in...

WCC Lite WCC Lite has 2 serial ports (Figure 7). Selectable RS485 (by default) or RS232 interface...