Recently Updated Pages

This document is intended to act as a user manual and explain WCC Lite usage in detail. It is exp...

It provides the main navigation through the website. Contains the following sections: PROTOC...

IEC 61499-1 defines the architecture for distributed systems. In IEC 61499 the cyclic execution m...

The PLC functionality in the WCC Lite is implemented using the Eclipse 4diac framework, consist...

After the PLC design is finished and debugged, such a design can be compiled into an FBOOT file a...

WCC Lite integrates 1 signal relay (3-way RO connector) with COM (common), NC (normally closed), ...

With WCC Lite hardware version 1.4, a digital input functionality has been introduced. Software c...

For hardware versions older than version 1.4, in case a Wi-Fi connection is needed, connect a Wi-...

WCC Lite comes with a static network configuration with its IP set to 192.168.1.1. For initial se...

Single point Commonly used in storing digital states single point values have only one bit of in...

WCC Lite WCC Lite has 2 serial ports (Figure 7). Selectable RS485 (by default) or RS232 interface...

WCC Lite comes with an optional GSM module.There are a few hardware configurations available:  ...

Introduction MQTT (short for MQ Telemetry Transport) is an open OASIS and ISO standard (ISO/IEC ...

Introduction MQTT (short for MQ Telemetry Transport) is an open OASIS and ISO standard (ISO/IEC ...

Introduction IEC 62056 is a set of standards for electricity metering data exchange by the Inter...

Introduction IEC 61107, currently IEC 62056-21, was an international standard for a computer pro...

Overview ConMod P1Modbus is a small industrial protocol converter for smart Meters with P1 inter...

Introduction This article describes how to configure Wcc Lite to export data to external servers...

  Figure 1: Front panel status indication

The page shows information about the current interface status, and its configurations, provides...