Recently Updated Pages

Overview Delta protocol is used to communicate with Delta inverters over serial communication. ...

Overview Comlynx protocol is used to communicate with Comlynx inverters over serial communicatio...

Overview The Aurora Protocol is a link layer communications protocol for use on point­-to-­point...

Overview At command protocol is used for communications with AT Commands. Configuration At com...

IEC 61850 is an international standard defining communication protocols for intelligent electroni...

IEC 60870-5-104 protocol (in short IEC 104) is a part of IEC Telecontrol Equipment and Systems St...

Configuring datapoints (slave) The IEC 60870­-5­-101 Slave in WCC Lite has to be configured in E...

IEC 60870 part 5 is one of the IEC 60870 set of standards which define systems used for telecontr...

Modbus is a communication protocol for use with its programmable logic controllers (PLCs). Modbus...

DNP3 (Distributed Network Protocol) is a set of communications protocols used between components ...

General SMS sender is a service that lets users configure WCC Lite to send SMS on a set tag trig...

SNMP (Simple Network Management Protocol) is an internet­ standard protocol for managing devices ...

The firmware of the WCC Lite features a built-­in API which is accessible via the web interface. ...

To log out of the device graphical user interface a logout button in the interface’s upper ri...

Edit groups On this page, user groups can be edited, deleted or added. Groups: name of the use...

The services tab shows the services of the device and contains the following subsections: The ...

It provides the main navigation through the website. Contains the following sections: PROTOC...

WCC Lite comes with a static network configuration with its IP set to 192.168.1.1. For initial se...

Single point Commonly used in storing digital states single point values have only one bit of in...

For hardware versions older than version 1.4, in case a Wi-Fi connection is needed, connect a Wi-...