Recently Updated Pages
5.3 SIM card slot
WCC Lite has an optional Dual-SIM card modem. To access both SIM cards, remove a transparent fron...
5.2 Power
It is recommended to power WCC Lite from 6W (minimum) 12-24V DC power supply. A full range is 5V ...
5.1 Mounting
To mount the device: Secure the top of the mounting clip onto a DIN rail. Push the bottom of ...
6.5 Wi-Fi
For hardware versions older than version 1.3, in case a Wi-Fi connection is needed, connect a Wi-...
6.4 GSM
WCC Lite comes with an optional GSM module.There are a few hardware configurations available: ...
6.3 Digital Input
With WCC Lite hardware version 1.4 a digital input functionality has been introduced. Software co...
6.2 Relay output
WCC Lite integrates 1 signal relay (3-way RO connector) with COM (common), NC (normally closed), ...
6.1 Serial port interfaces
WCC Lite WCC Lite has 2 serial ports (Figure 7). Selectable RS485 (by default) or RS232 interface...
5.4 Dual-SIM card slot
WCC Lite has an optional Dual-SIM card modem. To access both SIM cards, remove a transparent fron...
5.3 SIM card slot
WCC Lite has an optional Dual-SIM card modem. To access both SIM cards, remove a transparent fron...
5.2 Power
It is recommended to power WCC Lite from 6W (minimum) 12-24V DC power supply. A full range is 5V ...
5.1 Mounting
To mount the device: Secure the top of the mounting clip onto a DIN rail. Push the bottom of ...
6 WCC Lite interfaces
WCC lite supports various interfaces to be acquire data and control external circuitry. That incl...
5 Installing the WCC Lite
Mounting To mount the device:1. Secure the top of the mounting clip onto a DIN rail.2. Push the ...
Firmware
Instruction-->Download Drivers --> Download Utility --> Download Firmware --> Download
13.3 Modbus Slave
WCC Lite can act as one (or several) of slave devices in a communication line. This can be used t...
Documentation
Manual --> Download
User Manual
Introduction MV Beacon is a device used to send SMS messages about emergency conditions from ex...
22 MQTT
Introduction MQTT (short for MQ Telemetry Transport) is an open OASIS and ISO standard (ISO/IEC ...
18.2 Optional parameters for signals
The signals sheet contains all signals linked to devices. Each signal is defined in a single row....