Recently Updated Pages
1 Overview
This document is intended to act as a user manual and explain WCC Lite usage in detail. It is exp...
8.2 Site layout
It provides the main navigation through the website. Contains the following sections: PROTOC...
20.1 IEC 61499
IEC 61499-1 defines the architecture for distributed systems. In IEC 61499 the cyclic execution m...
20.2 4Diac framework
The PLC functionality in the WCC Lite is implemented using Eclipse 4diac framework, consisting ...
20.5 Debugging an IEC 61499 application
After a project has been built and binded to an existing Excel configuration, a user would normal...
20.6 Generating and uploading FORTE logic file
After the PLC design is finished and debugged, such design can be compiled into FBOOT file and up...
6.2 Relay output
WCC Lite integrates 1 signal relay (3-way RO connector) with COM (common), NC (normally closed), ...
6.3 Digital Input
With WCC Lite hardware version 1.4, a digital input functionality has been introduced. Software c...
6.5 Wi-Fi
For hardware versions older than version 1.4, in case a Wi-Fi connection is needed, connect a Wi-...
8.1 Initial Setup
WCC Lite comes with a static network configuration with its IP set to 192.168.1.1. For initial se...
8.3 Protocol Hub
Protocol HUB section stores configuration for every connected device. You can configure it by imp...
5.1 Mounting
To mount the device: Secure the top of the mounting clip onto a DIN rail. Push the bottom of ...
7 Tags
Single point Commonly used in storing digital states single point values have only one bit of in...
5.2 Power
It is recommended to power WCC Lite from 6W (minimum) 12-24V DC power supply. A full range is 5V ...
6.1 Serial port interfaces
WCC Lite WCC Lite has 2 serial ports (Figure 7). Selectable RS485 (by default) or RS232 interface...
5.3 SIM card slot
WCC Lite has an optional Dual-SIM card modem. To access both SIM cards, remove a transparent fron...
5.4 Dual-SIM card slot
WCC Lite has an optional Dual-SIM card modem. To access both SIM cards, remove a transparent fron...
6.4 GSM
WCC Lite comes with an optional GSM module.There are a few hardware configurations available: ...
4.2 Reset button
The reset button is located on the front panel of WCC Lite, to access it, remove a transparent fr...
USB Drivers
IOMod series devices has USB port for IO module configuration. Due to be accessible on some of Wi...