Recently Updated Pages
29.3 IEC 60870-5-104
IEC 60870-5-104 Master IEC 60870-5-104 protocol (in short IEC 104) is a part of IEC Telecontrol ...
29 IEC 60870-5
Introduction IEC 60870 part 5 is one of the IEC 60870 set of standards which define systems used...
IOMOD 16DI User Manual IEC 60870-5-103
Introduction IOMOD 16DI is small sized stand-alone Modbus (RTU) or IEC 60870-5-103 digital input...
19 WCC Lite internal signals
Overview The WCC Lite contains several internal data points for readout and control which can be...
14.6 IEC 60870-5-104 Slave
IEC 60870-5-104 Slave is designed not to lose data acquired from Master protocols. The data that ...
14.5 IEC 60870-5-104 Master
IEC 60870-5-104 protocol (in short IEC 104) is a part of IEC Telecontrol Equipment and Systems St...
4.2 Reset button
The reset button is located on the front panel of WCC Lite, to access it, remove a transparent fr...
17.1 DLMS/COSEM
Introduction IEC 62056 is a set of standards for electricity metering data exchange by Internati...
IEC 104 Slave Simulator for SCADA System
Initial Setup All you need to do to set up is to be connected to a network from which the SCADA ...
13.2 Modbus Master
Modbus communication contains a single Master and may include more than 1, but not more than 247 ...
22 Data Export
General Various protocols are made to transmit data points as they are generated. This is enough...
21 MQTT
Introduction MQTT (short for MQ Telemetry Transport) is an open OASIS and ISO standard (ISO/IEC ...
17.3 Elgama
Overview Elgama protocol is used for communications with Elagama elektronika electricity meters....
17.2 IEC 62056-21
Introduction IEC 61107 or currently IEC 62056-21, was an international standard for a computer p...
15.3 IEC 61850 Client
WCC Lite can be used as a master station to collect data from IEC 61850 compatible server devices...
15.2 IEC 61850 Server
WCC Lite can act as a IEC 61850 server to serve data to remote SCADA systems. For example, WCC Li...
14.4 IEC 60870-5-103 Master
The IEC 60870-5-103 protocol is a companion standard for the informative interface of protection ...
12.2 DNP 3.0 Master
Default group and variation sets are used to send commands. If slave devices support different gr...
16.13 M-Bus
Overview M-Bus or Meter-Bus is a protocol for the remote reading of water, gas, or electricity m...
16.12 Windlog
Overview Windlog protocol is used for communications with the Windlog data logger. Configuratio...