Recently Updated Pages

Overview Elgama protocol is used for communications with Elagama elektronika electricity meters....

General The virtual device is a device that you can use to calculate additional math or keep a c...

WCC Lite can be used as a master station to collect data from IEC 61850 compatible server devices...

WCC Lite can act as a IEC 61850 server to serve data to remote SCADA systems. For example, WCC Li...

Signal value might require some recalculation or signal update prior to being sent. Understandabl...

IEC 60870 part 5 is one of the IEC 60870 set of standards which define systems used for telecontr...

DNP3 (Distributed Network Protocol) is a set of communications protocols used between components ...

Figure 1: Front panel status indication

IEC 61850 is an international standard defining communication protocols for intelligent electroni...

To mount the device: Secure the top of the mounting clip onto a DIN rail. Push the bottom of ...

It is recommended to power WCC Lite from 6W (minimum) 12-24V DC power supply. A full range is 5V ...

WCC Lite has an optional Dual-SIM card modem. To access both SIM cards, remove a transparent fron...

WCC Lite has an optional Dual-SIM card modem. To access both SIM cards, remove a transparent fron...

Single point Commonly used in storing digital states single point values have only one bit of in...

The reset button is located on the front panel of WCC Lite, to access it, remove a transparent fr...

WCC Lite WCC Lite has 2 serial ports (Figure 7). Selectable RS485 (by default) or RS232 interface...

WCC Lite comes with an optional GSM module.There are a few hardware configurations available:  ...

WCC Lite integrates 1 signal relay (3-way RO connector) with COM (common), NC (normally closed), ...

WCC lite supports various interfaces to be acquire data and control external circuitry. That incl...

Mounting To mount the device:1. Secure the top of the mounting clip onto a DIN rail.2. Push the ...