Recently Updated Pages

Instruction-->Download Drivers --> Download Utility --> Download Firmware --> Download

WCC Lite can act as one (or several) of slave devices in a communication line. This can be used t...

Manual -->  Download

 Introduction MV Beacon is a device used to send SMS messages about emergency conditions from ex...

Introduction MQTT (short for MQ Telemetry Transport) is an open OASIS and ISO standard (ISO/IEC ...

The signals sheet contains all signals linked to devices. Each signal is defined in a single row....

General Various protocols are made to transmit data points as they are generated. This is enough...

WCC Lite is based on OpenWRT operating system. OpenWrt is described as a Linux distribution for e...

Devices that send unencrypted data are susceptible to attacks which might cause deliberate damage...

The IEC 60870-­5-­101 protocol is a companion standard for power system monitoring, control assoc...

Default group and variation sets are used to send static and event values. If master devices supp...

General SMS sender is a service that lets user configure WCC Lite to send SMS on a set tag trigg...

The page shows information about current interface status, its configurations, provides various...

To log out of the device graphical user interface a logout button in the interface’s upper righ...

IEC 60870 part 5 is one of the IEC 60870 set of standards which define systems used for telecontr...

Modbus is a serial communications protocol for use with its programmable logic controllers (PLCs)...

DNP3 (Distributed Network Protocol) is a set of communications protocols used between components ...

SNMP (Simple Network Management Protocol) is an internet­standard protocol for managing devices o...

The firmware of the WCC Lite features a built­in API which is accessible via the web interface. A...

Configuring datapoints (slave) To use IEC 60870­-5­-101 Slave in WCC Lite, it has to be configur...