Recently Updated Pages

The page shows information about current interface status, its configurations, provides various...

To log out of the device graphical user interface a logout button in the interface’s upper righ...

IEC 60870 part 5 is one of the IEC 60870 set of standards which define systems used for telecontr...

Modbus is a serial communications protocol for use with its programmable logic controllers (PLCs)...

DNP3 (Distributed Network Protocol) is a set of communications protocols used between components ...

SNMP (Simple Network Management Protocol) is an internet­standard protocol for managing devices o...

The firmware of the WCC Lite features a built­in API which is accessible via the web interface. A...

Configuring datapoints (slave) To use IEC 60870­-5­-101 Slave in WCC Lite, it has to be configur...

IEC 60870-5-104 Slave is designed not to lose data acquired from Master protocols. The data that ...

Modbus communication contains a single Master and may include more than 1, but not more than 247 ...

In order to get the WCC Liteup and running, a PC/Mac is required, capable of running a web browse...

Overview System System section in the status tab shows basic information about the current stat...

Services tab shows the services of the device and contains the following subsections: Services...

Figure 1: Front panel status indication

System Processor ARM CPU (AR9331, 400MHz) Memory 16 MB Flash/64 MB DDR2 RAM Wire...

IEC 61850 is an international standard defining communication protocols for intelligent electroni...

The reset button is located on the front panel of WCC Lite, to access it, remove a transparent fr...

IEC 60870-5-104 protocol (in short IEC 104) is a part of IEC Telecontrol Equipment and Systems St...

Devices sheet contains all devices to be configured on the gateway. Each row represents one devic...

Introduction IEC 61107 or currently IEC 62056-21, was an international standard for a computer p...