Recently Updated Pages

IEC 60870-5-104 protocol (in short IEC 104) is a part of IEC Telecontrol Equipment and Systems St...

The IEC 60870-5-103 protocol is a companion standard for the informative interface of protection ...

The IEC 60870-­5-­101 protocol is a companion standard for power system monitoring, control assoc...

Configuring datapoints (slave) The IEC 60870­-5­-101 Slave in WCC Lite has to be configured in E...

Default group and variation sets are used to send static and event values. If master devices supp...

Default groups and variation sets are used to send commands. If slave devices support different g...

Default groups and variation sets are used to send commands. If slave devices support different g...

Default group and variation sets are used to send static and event values. If master devices supp...

Modbus communication contains a single Master and may include more than 1, but not more than 247 ...

Modbus communication contains a single Master and may include more than 1, but not more than 247 ...

The execution_signal parameter returns information about the specific signal that triggered execu...

To get the WCC Lite up and running a PC/Mac is required, capable of running a web browser and an ...

General SMS sender is a service that lets users configure WCC Lite to send SMS on a set tag trig...

The firmware of the WCC Lite features a built-­in API which is accessible via the web interface. ...

System The system tab includes various properties, configurations, and settings of the system an...

The services tab shows the services of the device and contains the following subsections: The ...

The page shows information about the current interface status, and its configurations, provides...

  Figure 1: Front panel status indication

System Processor MIPS CPU (AR9331, 400MHz) Memory 16 MB Flash/64 MB DDR2 RA...

There are two types of command signals used in SMS Receivers: System: reboot wcc/reboot mod...