Recently Updated Pages
12.2 DNP 3.0 Master
Default group and variation sets are used to send commands. If slave devices support different gr...
IOMOD 4RTD User Manual IEC 60870-5-101
Introduction IOMOD 4RTD is used for temperature data monitoring over Modbus or IEC-60...
IOMOD 4RTD User Manual IEC 60870-5-103
Introduction IOMOD 4RTD is used for temperature data monitoring over Modbus or IEC-60870-103 usi...
IOMOD 4RTD User Manual Modbus
Introduction IOMOD 4RTD is used for temperature data monitoring over Modbus or IEC-60870-103 usi...
22 MQTT
Introduction MQTT (short for MQ Telemetry Transport) is an open OASIS and ISO standard (ISO/IEC ...
18.1 Devices sheet
Devices sheet contains all devices to be configured on the gateway. Each row represents one devic...
18.1 Devices sheet
Devices sheet contains all devices to be configured on the gateway. Each row represents one devic...
Device configuration
Protocol HUB uses configuration in excel file format. Each sheet represents a specific part of co...
DLMS Serial to IEC104 protocol conversion
Description The article describes WCC Lite configuration steps to enable DLMS Serial ...
24 Certificates
Devices that send unencrypted data are susceptible to attacks which might cause deliberate damage...
14.6 IEC 60870-5-104 Slave
Since firmware version 1.8.3, multiple signals with different data types can have same ioa addres...
8.5 System
System The system tab includes various properties, configurations, and settings of the system an...
8.4 Status
Overview System System section in the status tab shows basic information about the current st...
IOMOD 8DI4RO User Manual IEC 60870-5-101
Introduction IOMod 8DI4RO is a small-size stand-alone Modbus RTU, IEC 60870-5-103 or IEC-60870-5...
14.3 IEC 60870-5-101 Slave
Configuring datapoints (slave) To use IEC 60870-5-101 Slave in WCC Lite, it has to be configur...
14.4 IEC 60870-5-103 Master
The IEC 60870-5-103 protocol is a companion standard for the informative interface of protection ...
14.5 IEC 60870-5-104 Master
IEC 60870-5-104 protocol (in short IEC 104) is a part of IEC Telecontrol Equipment and Systems St...
2 Hardware and software requirements
In order to get the WCC Lite up and running, a PC/Mac is required, capable of running a web brows...
13.3 Modbus Slave
WCC Lite can act as one (or several) of slave devices in a communication line. This can be used t...
12.3 DNP 3.0 Slave
Default group and variation sets are used to send static and event values. If master devices supp...