Recently Updated Pages
20.6 Generating and uploading FORTE logic file
After the PLC design is finished and debugged, such design can be compiled into FBOOT file and up...
20.5 Debugging an IEC 61499 application
After a project has been built and binded to an existing Excel configuration, a user would normal...
3 Technical information
System Processor ARM CPU (AR9331, 400MHz) Memory 16 MB Flash/64 MB DDR2 RAM Wire...
1 Overview
This document is intended to act as a user manual and explain WCC Lite usage in detail. It is exp...
IOMOD 8DI8DO User Manual IEC 60870-5-103
Introduction IOmod 8DI8DO is a small size stand-alone Modbus RTU or IEC 60870-5-103 digital inpu...
18.3 Mathematical functions
Signal value might require some recalculation or signal update prior to being sent. Understandabl...
Modbus RTU to IEC104 protocol conversion
Description This article describes WCC Lite configuration steps to enable Modbus TCP protocol co...
Capture packets using tcpdump
Description This article describes how to log packets using tcpdump. Installing tcpdump Before...
IEC 61850 interoperability with IEC 104
IEC 61850 Server WCC Lite can act as a IEC 61850 server to serve data to remote SCADA systems. F...
WCC Excel utility
WCC Excel Utility app can be used to: Upload configurations to WCC Lite device. App checks if ...
Single point to double point and double point to single point information
Single point to double point information For this example of changing single point information t...
Firmware update
To upgrade the FW of wcc lite, in the web interface go to system -> backup/flash firmware and upl...
Selecting specific bit as data (using bit_select)
Description Some devices send single-point data (0 and 1) in one register. To access the individu...
16.14 KOSTAL
Overview Kostal protocol is used to communicate with Kostal devices over serial communication. ...
16.10 VBUS
Overview Vbus is a protocol used for communication with solar station automation via serial link...
16.11 VESTAS
Overview Vestas is a protocol used for communication with solar station automation via serial li...
16.12 Windlog
Overview Windlog protocol is used for communications with the Windlog data logger. Configuratio...
16.13 M-Bus
Overview M-Bus or Meter-Bus is a protocol for the remote reading of water, gas, or electricity m...
16.2 Aurora
Overview The Aurora Protocol is a link layer communications protocol for use on point-to-poi...
16.3 COMLYNX
Overview Comlynx protocol is used to communicate with Comlynx inverters over serial communicatio...