Recently Updated Pages

After the PLC design is finished and debugged, such design can be compiled into FBOOT file and up...

Overview At command protocol is used for communications with AT Commands. Configuration At com...

Overview The Aurora Protocol is a link layer communications protocol for use on point­to­point...

Overview Comlynx protocol is used to communicate with Comlynx inverters over serial communicatio...

Overview Vbus is a protocol used for communication with solar station automation via serial link...

Overview Vestas is a protocol used for communication with solar station automation via serial li...

Overview Windlog protocol is used for communications with the Windlog data logger. Configuratio...

Overview M-Bus or Meter-Bus is a protocol for the remote reading of water, gas, or electricity m...

General The virtual device is a device that you can use to calculate additional math or keep a c...

Signal value might require some recalculation or signal update prior to being sent. Understandabl...

Configuring datapoints (slave) To use IEC 60870­-5­-101 Slave in WCC Lite, it has to be configur...

WCC Lite can act as one (or several) of slave devices in a communication line. This can be used t...

Introduction Modbus is a serial communications protocol for use with its programmable logic cont...

Modbus is a communications protocol originally published by Modicon (now Schneider Electric) in 1...

IEC 60870-5-104  is a protocol for power system monitoring and controlling. Mostly used to commun...

Tags have different functionalities for both Master and Slave simulations. Slave: Tags in Sla...

Placement Filter and Format buttons can be found at the bottom right side of the Console window,...

The IEC 60870-­5-­101 protocol is a companion standard for power system monitoring, control assoc...

Fiber Optic LIGHT ON/OFF mode button – by pressing this button you can easily convert Fiber Optic...

General Various protocols are made to transmit data points as they are generated. This is enough...