Recently Updated Pages
IEC 104 Slave Simulator for SCADA System
Initial Setup All you need to do to set up is to be connected to a network from which the SCADA ...
13.2 Modbus Master
Modbus communication contains a single Master and may include more than 1, but not more than 247 ...
22 Data Export
General Various protocols are made to transmit data points as they are generated. This is enough...
21 MQTT
Introduction MQTT (short for MQ Telemetry Transport) is an open OASIS and ISO standard (ISO/IEC ...
17.3 Elgama
Overview Elgama protocol is used for communications with Elagama elektronika electricity meters....
17.2 IEC 62056-21
Introduction IEC 61107 or currently IEC 62056-21, was an international standard for a computer p...
15.3 IEC 61850 Client
WCC Lite can be used as a master station to collect data from IEC 61850 compatible server devices...
15.2 IEC 61850 Server
WCC Lite can act as a IEC 61850 server to serve data to remote SCADA systems. For example, WCC Li...
14.4 IEC 60870-5-103 Master
The IEC 60870-5-103 protocol is a companion standard for the informative interface of protection ...
12.2 DNP 3.0 Master
Default group and variation sets are used to send commands. If slave devices support different gr...
16.13 M-Bus
Overview M-Bus or Meter-Bus is a protocol for the remote reading of water, gas, or electricity m...
16.12 Windlog
Overview Windlog protocol is used for communications with the Windlog data logger. Configuratio...
16.11 VESTAS
Overview Vestas is a protocol used for communication with solar station automation via serial li...
16.10 VBUS
Overview Vbus is a protocol used for communication with solar station automation via serial link...
16.9 SOLPLUS
Overview Solplus protocol is used to download inverter data from Solplus inverters using a HTTP ...
16.8 SMA NET
Overview SMA Net can transfer SMA Data, TCP/IP and many more telegrams due to its multiprotocol...
16.7 POWERONE
Overview PowerOne protocol is used to communicate with Aurora inverters over serial communicatio...
16.6 KOSTAL
Overview Kostal protocol is used to communicate with Kostal devices over serial communication. ...
16.6 Kaco
Overview This protocol is meant to be used by inverters that convert the DC power generated by t...
16.5 GINLONG
Overview Ginlong protocol is used to communicate with Ginlong inverters over serial communicatio...