Recently Updated Pages

This document is intended to act as a user manual and explain WCC Lite usage in detail. It is exp...

The signals sheet contains all signals linked to devices. Each signal is defined in a single row....

There are two types of command signals used in SMS Receiver: System: reboot wcc/reboot mode...

SMS receiver is a service responsible for command execution that were received via text message. ...

WCC Lite can act as an IEC 61850 server to serve data to remote SCADA systems. For example, WCC L...

Introduction IOMOD HT is used for temperature and humidity data monitoring over Modbus (RTU), IE...

The Vinci Software ->  Download More information about changes in software can be found here -> ...

Description   The article describes WCC Lite configuration steps to enable DLMS Serial ...

ConMod P1 Manual Manual -> Download

General SMS sender is a service that lets user configure WCC Lite to send SMS on a set tag trigg...

Description Since 1.5 firmware version some configuration parameters stopped existing, new ones ...

Lua device can be configured using cron time expression. This way script execution can be schedul...

The firmware of the WCC Lite features a built-­in API which is accessible via the web interface. ...

Modbus communication contains a single Master and may include more than 1, but not more than 247 ...

WCC Lite has an optional Dual-SIM card modem. To access both SIM cards, remove a transparent fron...

Default group and variation sets are used to send commands. If slave devices support different gr...

Introduction MQTT (short for MQ Telemetry Transport) is an open OASIS and ISO standard (ISO/IEC ...

Devices sheet contains all devices to be configured on the gateway. Each row represents one devic...

Devices sheet contains all devices to be configured on the gateway. Each row represents one devic...

Protocol HUB uses configuration in excel file format. Each sheet represents a specific part of co...