Recently Updated Pages

DNP3 (Distributed Network Protocol) is a set of communications protocols used between components ...

General SMS sender is a service that lets users configure WCC Lite to send SMS on a set tag trig...

SNMP (Simple Network Management Protocol) is an internet­ standard protocol for managing devices ...

The firmware of the WCC Lite features a built-­in API which is accessible via the web interface. ...

To log out of the device graphical user interface a logout button in the interface’s upper ri...

Edit groups On this page, user groups can be edited, deleted or added. Groups: name of the use...

The services tab shows the services of the device and contains the following subsections: The ...

It provides the main navigation through the website. Contains the following sections: PROTOC...

WCC Lite comes with a static network configuration with its IP set to 192.168.1.1. For initial se...

Single point Commonly used in storing digital states single point values have only one bit of in...

For hardware versions older than version 1.4, in case a Wi-Fi connection is needed, connect a Wi-...

WCC Lite comes with an optional GSM module.There are a few hardware configurations available:  ...

With WCC Lite hardware version 1.4, a digital input functionality has been introduced. Software c...

WCC Lite integrates 1 signal relay (3-way RO connector) with COM (common), NC (normally closed), ...

WCC Lite WCC Lite has 2 serial ports (Figure 7). Selectable RS485 (by default) or RS232 interface...

WCC Lite has an optional dual-SIM card modem. To access both SIM cards, remove a transparent fron...

It is recommended to power WCC Lite from a 6W (minimum) 12-24V DC power supply. A full range is 5...

To mount the device: Secure the top of the mounting clip onto a DIN rail. Push the bottom of ...

The reset button is located on the front panel of WCC Lite, to access it, remove a transparent fr...

To get the WCC Lite up and running a PC/Mac is required, capable of running a web browser and an ...