Skip to main content

How To

Explaining documents how to setup.

Connect to WCC Lite

In order to connect to the WCC Lite: Power up the WCC Lite Once the WCC Lite boots up, plug an...

WAN IP Setup

Description One o the first steps in RTU/Datalogger setting up is to prepare connection to inter...

Enable Internet or WAN for connected devices

In order to enable connected devices communication through the router it is needed to enable Masq...

Capture packets using tcpdump

Description This article describes how to log packets using tcpdump. Installing tcpdump Before...

IOMod setup with WCC Lite

In this chapter you will learn how to connect all kinds of Elseta IOMods to the WCC Lite

Protocol conversions

Firmware update

To upgrade the firmware (FW) of the WCC Lite, open the web interface and navigate to System → Bac...

Lua runner examples

Selecting specific bit as data (using bit_select)

Description Some devices send single-point data (0 and 1) in one register. To access the individu...

IEC 61850 interoperability with IEC 104

IEC 61850 Server WCC Lite can act as a IEC 61850 server to serve data to remote SCADA systems. F...

WCC Excel utility

WCC Excel Utility app can be used to: Upload configurations to WCC Lite device. App checks if ...

Single point to double point and double point to single point information

Single point to double point information This example shows how to convert single point informat...

Firmware 1.5 and 1.8 configurations comparison

Description Since 1.5 firmware version some configuration parameters stopped existing, new ones ...

SNMP

Description This article describes installing, setting up and monitoring SNMP with WCC Lite. In...

M-Bus Serial Communication Setup Guide

Description This article describes how to establish communication between WCC Lite and a meter u...

Add ssh-key

Functionality The SSH key functionality in the WCC Lite device allows you to authenticate secure...

Data Export

Introduction This article describes how to configure Wcc Lite to export data to external servers...

Enable Ser2net on WCC Lite

Ser2net is a service available on WCC Lite that allows you to bridge serial ports over a TCP/IP n...

Firmware 1.7.0 and 1.11 configurations comparison

Description This document summarizes configuration differences between WCC Lite firmware version...