Skip to main content

11 SMS sender

General

SMS sender is a service that lets user configure WCC Lite to send SMS on a set tag trigger.s

SMS sender functionality is available since firmware version v1.5.4, of WCC Lite.

Configuring SMS sender

To configure WCC Lite to use SMS sender user must fill in the needed parameters in Excel configuration. These parameters are shown in the tables below. 

SMS sender parameters for Devices tab:

Parameter

Type

Description

Required

Default value

(when not specified)

Range

Min

Max

name string User-friendly device name Yes


description string Description of the device No


device_alias string Device alias to be used in configuration Yes


enable boolean Enabling/disabling of a device No 1 0 1
protocol string Selection of protocol Yes
SMS sender
host string List of phone numbers to send SMS to, separated by space. Yes


image-1632837719431.png

SMS sender parameters for Signals tab:

Parameter

Type

Description

Required

Default value

(when not specified)

Range

Min

Max

signal_name string User-friendly signal name Yes

 



device_alias string Device alias from a Devices tab Yes


signal_alias string Unique signal name to be used Yes


source_device_alias string device_alias of the source device No


source_signal_alias string source_alias of the source signal No


enable boolean Enabling/disabling of a signal No 1 0 1
log  integer Enable logging in event log  No 0 0
job_todo string Specific SMS sender tag type Yes
send-sms, device-control, device-status
tag_job_todo string

SMS sender tag for send-sms:

text message

Yes

trigger string Trigger expression for the SMS to be sent No (Only for send_sms) value!=0

To configure SMS sender, 3 types of signals are mandatory. These values should be written inside the job_todo field for each signal:

  • send-sms - This signal takes value from the provided source_signal_alias field and checks if the value evaluates as true against the trigger field. If its true, the SMS sender will send the text from the tag_job_todo field to the specified phone numbers. 
  • device-control - This signal controls if the SMS sender is enabled or disabled. Its tag_job_todo parameter should be set to enable. It takes value from the source_signal_alias field and evaluates it against the trigger field. If the trigger is evaluated as true, the SMS sender will be enabled, otherwise it will disable the SMS sender.
  • device-status - This signal indicates if the service is enabled or not. Its tag_job_todo parameter should be set to enabled. 

Trigger expressions can be configured with basic comparison operators:

  • Less than <
  • Greater than >
  • Less than or equal to <=
  • Greater than or equal to >=
  • Equal ==
  • Not equal !=

Example configuration of SMS sender:

image-1632898451171.png